Using 'bucking' batteries: The voltage of the smaller battery is subtracted from the larger battery and the positive end of the smaller battery becomes the negative end of the two. This really works.

An interactive diode, battery and lamp circuit built in the DCACLab online simulator by Sam Watson. Open it to run the simulation and measure it.

Preview of Using 'bucking' batteries: The voltage of the smaller battery is subtracted from the larger battery and the positive end of the smaller battery becomes the negative end of the two. This really works.

Open in the lab Embed The simulation runs as a demo that pauses after two minutes; open it in the lab to keep going.

Ensina com circuitos?

Crie uma turma, passe um circuito para os alunos montarem e revise o que eles entregam. Experimente grátis com uma turma e até 5 alunos.

Experimente a demo de turma grátis

What's inside

2× Battery (1 V)
1× Diode
1× Lamp
Measured with Multimeter

About

By Sam Watson
Saved July 10, 2014 · updated January 15, 2026
5,761 views
Page: dcaclab.com/circuits/9983-using-a-car-battery-and-two-aas-to-make-a-9-volt-battery

Embed this circuit

<iframe src="https://dcaclab.com/experiments/9983-using-a-car-battery-and-two-aas-to-make-a-9-volt-battery/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Watson, S. (2014). Using 'bucking' batteries: The voltage of the smaller battery is subtracted from the larger battery and the positive end of the smaller battery becomes the negative end of the two. This really works. DCACLab. https://dcaclab.com/circuits/9983-using-a-car-battery-and-two-aas-to-make-a-9-volt-battery